400 Watts "peak" available power
800 Watts "peak" available power when connecting an additional passive 8 Ohm enclosure to the speaker out
Two-way powered sound reinforcement enclosure
DDT™ compression/anti-clipping protection
Signal input via combo female XLR/ 1/4" phone jack, providing balanced operation
Constant directivity tweeter horn, 60° X 40°
Contour switch provides bass and treble lift
Heavy-duty crossover network with high frequency driver protection
Steel handles and protective corners
Full-coverage heavy-duty perforated steel grill with powder coat finish
RX™14 titanium diaphragm compression driver, with 1.4" titanium diaphragm
Steel pole mount adapter
Peavey® exclusive 15" heavy-duty woofer with 2 3/8" voice coil & 50 oz. magnet
T-Nut speaker mounting
Class-D powered system with up to 800 W total peak available power
Power amp output jack available to power another passive speaker
Carpet covered trapezoidal enclosure
Frequency Range: 1 meter on-axis, swept-sine in 1/2 Space environment, -10 dB: 46 Hz to 21 kHz
Frequency Response: 1 meter on-axis, swept-sine in 1/2 Space environment 66 Hz to 17 kHz (± 3 dB)
Sensitivity (1w/1m): 95 dB
Maximum Peak SPL: 121 dB
Transducer Compliment: Transducer Compliment: Heavy-duty 15” woofer with 2 3/8” voice coil & 50 oz. magnet. RX™14 1.4” titanium diaphragm dynamic compression driver, on a Constant Directivity 60 X 40 horn.
Nominal Coverage Pattern: 60 degrees horizontal by 40 degrees vertical
Electro-acoustic Crossover Frequency: 3 kHz
Input Connections: One combo female XLR/ 1/4” phone jack providing balanced or unbalanced operation.
Enclosure Materials & Finish: Trapezoidal, black carpet covered 12mm MDF, black powder-coated full length perforated steel grille.
Mounting or Suspension: Steel 1 3/8” pole-mount cup for stand mounting, four rubber feet for floor use.
NOTE: This unit is not designed for overhead suspension!
ELECTRONICS AND AMPLIFIER SPECIFICATIONS: Power Amp Rating
Total Power Output: 800 watts peak available power
Continuous Power: 400 watts into 4 ohms @ less than 1% distortion
Electronic Input Impedance (Nominal): 2.7 k ohms balanced (XLR or 1/4”), 1.35 k ohms unbalanced 1/4”.
Infrasonic filter protection: 24 dB/octave roll-off
Nominal Amplifier Frequency Response: +0, -3 dB from 20 Hz to 20 kHz
Hum and Noise: Greater than 90 dB below rated power
DDT Dynamic Range: Greater than 14 dB
THD and IM: Typically less than 0.5 %
Damping Factor: Greater than 400 @ 1000 Hz, 8 Ohms
Power requirements of Peavey PV®115D System: Nominal 370 Watts, Voltage and Frequency Ranges: 100-120 VAC, and 220 – 240VAC, at 50- 60 Hz
Fuse Type: For 100-120 VAC USE: International fuse classification T6.3AL . In the USA, types GDC, GMC, 215, 218, and 477 cartridge-style 5 x 20
mm size fuses with a 6.3 amp 250V rating can be used.
For 220-240 VAC USE: International fuse classification T3.15AL . This is a cartridge style 5 x 20 mm size time-delay fuse with a 3.15 amp 250V rating.