The Peavey Solo Portable PA has 2 input channels and an 8" speaker for a great portable solution!
The Solo Portable PA is lightweight and can be used for a traveling ministry, youth group or street evangelist. Easy to set-up and take down so you can use it almost anywhere!
8 inch heavy-duty speaker Two channels Mic channel features low Z input 2-band EQ Tape out jack AC adapter or battery power (not included) High and low impedance inputs Lightweight, fully self-contained 15 watts (rms) from AC power 10 watts (rms) from battery power
Rated Power & Load - 15W RMS into 3.2 ohms Power @ Clipping - (Typically @ 1kHz 3.2 ohms) (Use external Power Pack @ 120 VAC or external regulated + 12 VDC Source): 15W RMS @ 5% THD (Using internal "New" batteries @ 12 VDC): 10W RMS @ 5% THD Frequency Response: +0. -3 dB, 80Hz to 10 kHz @ 1 watt into 3.2 ohms Total Harmonic Distortion: Less than 0.3%, 100 mW to 10W RMS 80 Hz to 10 kHz, 3.2 ohmd Typically below 0.2% Power Consumption (External Power Pack): 40 watts @ 120 VAC. 50/60 Hz Power Consumption (Optional 12V Adapter): 12-17 VDC. Negative Ground 24 Watts @ 12 VDC. 2 ADC Battery Complement: Eight Size "D". 1.5 Volt (ANSI-L90) (Alkaline Type Recommended) PreAmp Selection: The following specs are measured @ 1 kHz with the Low and High EQ controls set @ 5 Nominal Level is with Gains @ 5 Minimum Level is with Gains @ 10 Low Z Microphone Input: Input Impedance: Low Z, 3.3K ohms Nominal Input Level: -36dBV, 15 mV RMS Minimum Input Level: -54 dBV, 2 mV RMS Maximum Input Level: +6 dBV. 2.0V RMS High Z Microphone Input: Input Impedance: High Z. 33K ohms Nominal Input Level: -16 dBV, 150 mV RMS Minimum Input Level: -34 dBV. 20 mV RMS Maximum Input Level: +26 dBV. 20V RMS High Z Auxiliary Input: Input Impedance: Very High Z. 2.2M ohms Nominal Input Level: -20 dBV, 100 mV RMS Minimum Input Level: -36 dBV, 16mV RMS Maximum Input Level: 0 dBV, 1.0V RMS System Hum & Noise: (Measured @ Nominal Levels. 20 Hz to 20 kHz unweighted) 80 dB below rated power Equalization: (Low & High Active Type) +/-12 dB @ 80 Hz & 5kHz Tape Output: Load Impednace: 10K ohms or greater Designed Output: -20 dBv. 0.1V RMS
You may also be interested in the following product(s)